Get matched with top roofing installation & roof repairers in Berkeley-Township, NJ

"Quality of work was amazing, communication was great. Would highly recommend Home Genius and will be using them for future projects!"

"Not professional, does not pay attention to detail. Do not cleanup after themselves. Spent over $10000 fixing things they broke. Extremely unhappy!"

"Outstanding work by Emmons Roofing & Siding on my roof and attic insulation in 2017. I would highly recommend this Company."

"Great company from the owner to all the employees. Easy process. Very professional. The job was completed on time and the workers were probably the best team that I have encountered . Clean , honest, and a pleasure to deal with. Great company. Would recommend them 100%."

"High Tech was very professional and reasonable. They communicated well along the process and I couldn't be any happier with the outcome. I look foward to working with them again for future home improvements."

"We highly recommend Eddie Costa home improvement. They were very professional. Staff was very polite. The work was done in a day for a complete roof replacement. We are very pleased with the work we highly recommend them we will hire them again. We were so pleased. We were so pleased we’re having them do more work for us. Thanks again etc home improvement, staff. CN"

"This past weekend I had a bad experience. The short story is that an A. J. Perri technician diagnosed my furnace problem and wrote me an estimate for $1,600, parts and labor. It turns out my furnace had a different problem that required no parts and only 15 minutes of labor. Here are the details: This past Saturday my furnace stopped heating my home. I called A.J. Perri and they sent out a technician on Sunday morning. The tech ran some checks and concluded that my “inducer assembly” had to be replaced. Parts and installation would be $1,600. He said someone from the office would contact me on Monday and let me know when they could have the part. He also said that he couldn't be certain that there weren't other issues that wouldn't be found until the inducer was repaired. After the technician left I did some searching on the Internet. YouTube and Reddit were especially helpful. I discovered that the problem was that the condensate drain was clogged and water had backed up into the inducer assembly. The water prevented the pressure switches from detecting that the inducer was running and this prevented the furnace from starting. When I disconnected the condensate hose *2 quarts* of water drained out of the inducer assembly! This water was supposed to drain into a small pump unit on the floor that sends collected water to the sump. Over the years mold and algae had clogged the condensate trap and caused the backup. I disconnected all the hoses and removed the trap. I blew out the trap (making a mess) and confirmed that water would easily flow through it. I put it all back together and the furnace is working fine. The sad lesson here is that you can’t always rely on supposed experts. The good news is that the Internet can be your friend. Even more details: The original symptom was that the furnace would start up, the inducer motor would run for about 20 seconds and then it would shut off. This cycle would repeat every few minutes. Every few hours the furnace completed the startup cycle and then I’d get heat. Then it would stop heating for hours, and the indoor temperature would drop to the low 60s. What I learned from YouTube is that there are multiple stages for furnace startup. The inducer motor spins a cage that sucks in fresh air for combustion, and then pushes the hot gases through the heat exchanger and out the flue. Each stage in the startup has safety checks. The furnace will not ignite if the pressure sensors don’t detect that the inducer motor is working properly. Water is a byproduct of the combustion. It starts as a vapor but then condenses in the flue pipe and drains back to the inducer assembly, where it’s supposed to run through a hose to a pump that sends it over to my basement sump. The furnace is 14 years old. Apparently that’s long enough for mold and algae to clog the condensate trap and cause water to back up into the inducer. The 2 qts of water blocked the pressure sensor switches and so the furnace wouldn’t light. Final thoughts: For over 14 years I've had great experiences with A.J. Perri. They replaced my home’s original furnace and Air Conditioner units. They moved our outside A/C unit to the side of our house so we could have more quiet in the backyard. I had them come for periodic heating and A/C maintenance checkups. My impression is that they might cost a bit more, but they were reliable. I'm saddened that I need to post such a negative review."

"*Many major issues with the work completed. *A lot of sloppy work , indifferent workers *The sub flooring was not installed or not properly installed causing adjoining room floors to be different levels than the newly installed floor. The previous flooring was level with all rooms throughout the 1st floor. *There are 3 significant "bumps" in flooring as the sub flooring was not installed or properly installed. Standard industry practice ;of leveling out bumps was not followed. SEE HOME DEPOT Instructions. *Contractor would not fix floor and simply installed high sills which are a tripping hazard in the same doorways for we had widened by contractor since we are over 70 with limited mobility, *Damaged stairs when removing old materials *Charged for services not done and for materials not used *Did not replace 60 year old sink/toilet shut-off valves when "modernizing bathrooms. *Water lines installed by contractor broke two times. *Work failed Building Inspection and contractor indicated he would not fix issues, he said "he was moving on". *Anderson windows installed were the wrong size ;54" instead of the 48" as other existing windows in house. *Four new doors were installed and one is different than the other 3. Two facing doors at end of hall do not match each other. *Tile work in new bathroom is not fully level and spacing of grout work is inconsistent. Contractor did try to correct but still a problem."