Get matched with top wood retaining wall builders in Eagleville, PA

"Working with DJ from Groundworks (Select Basement) has been an outstanding experience. After struggling with various contractors who either failed to resolve our water issues or were unprofessional, DJ and his team truly stood out. DJ was incredibly helpful, patient, and responsive throughout the entire process. Our home is a ranch with 225 linear feet around the perimeter, and while other contractors insisted on installing a French drain for the entire length, DJ recommended a more targeted approach. He proposed installing the French drain for just 80 linear feet, focusing only on the areas where water intrusion was likely. His thorough explanations and prompt responses to all our questions were greatly appreciated. The workers arrived on time, maintained a clean work environment, and completed the job as promised. If we could give 10 stars, we would! Groundworks is a highly professional and honest company that didn't try to inflate the scope of work to charge us more. We wholeheartedly recommend them."

"Angel and his crew were very reliable and the work was performed in the timeframe they provided. Steps look beautiful!"

"Lawrence Site Contractors did an amazing job replacing our front porch. They were thorough, cleaned up after the job, and were very pleasant to work with. They came when they said they would, and communication was great. I highly recommend them."

"They were efficient and knew their stuff!"

"This past weekend I had a bad experience. The short story is that an A. J. Perri technician diagnosed my furnace problem and wrote me an estimate for $1,600, parts and labor. It turns out my furnace had a different problem that required no parts and only 15 minutes of labor. Here are the details: This past Saturday my furnace stopped heating my home. I called A.J. Perri and they sent out a technician on Sunday morning. The tech ran some checks and concluded that my “inducer assembly” had to be replaced. Parts and installation would be $1,600. He said someone from the office would contact me on Monday and let me know when they could have the part. He also said that he couldn't be certain that there weren't other issues that wouldn't be found until the inducer was repaired. After the technician left I did some searching on the Internet. YouTube and Reddit were especially helpful. I discovered that the problem was that the condensate drain was clogged and water had backed up into the inducer assembly. The water prevented the pressure switches from detecting that the inducer was running and this prevented the furnace from starting. When I disconnected the condensate hose *2 quarts* of water drained out of the inducer assembly! This water was supposed to drain into a small pump unit on the floor that sends collected water to the sump. Over the years mold and algae had clogged the condensate trap and caused the backup. I disconnected all the hoses and removed the trap. I blew out the trap (making a mess) and confirmed that water would easily flow through it. I put it all back together and the furnace is working fine. The sad lesson here is that you can’t always rely on supposed experts. The good news is that the Internet can be your friend. Even more details: The original symptom was that the furnace would start up, the inducer motor would run for about 20 seconds and then it would shut off. This cycle would repeat every few minutes. Every few hours the furnace completed the startup cycle and then I’d get heat. Then it would stop heating for hours, and the indoor temperature would drop to the low 60s. What I learned from YouTube is that there are multiple stages for furnace startup. The inducer motor spins a cage that sucks in fresh air for combustion, and then pushes the hot gases through the heat exchanger and out the flue. Each stage in the startup has safety checks. The furnace will not ignite if the pressure sensors don’t detect that the inducer motor is working properly. Water is a byproduct of the combustion. It starts as a vapor but then condenses in the flue pipe and drains back to the inducer assembly, where it’s supposed to run through a hose to a pump that sends it over to my basement sump. The furnace is 14 years old. Apparently that’s long enough for mold and algae to clog the condensate trap and cause water to back up into the inducer. The 2 qts of water blocked the pressure sensor switches and so the furnace wouldn’t light. Final thoughts: For over 14 years I've had great experiences with A.J. Perri. They replaced my home’s original furnace and Air Conditioner units. They moved our outside A/C unit to the side of our house so we could have more quiet in the backyard. I had them come for periodic heating and A/C maintenance checkups. My impression is that they might cost a bit more, but they were reliable. I'm saddened that I need to post such a negative review."

"These guys were pros from the start to the finish. Professional, neat, orderly and respectful. Did excellent work and our back yard has never looked better. I would recommend Madden Landscaping to everyone."

"Michael and Son's water mitigation team came out the same day, and had dehumidifiers and air movers placed by the following afternoon. Oscar was supervising the team, and he was great in not only explaining what he was doing and why, but walking me through the insurance process as well. As far as the end results are concerned, there is a hole in our ceiling and about a third of the bathroom tile has been pulled up, as well as one level of flooring that was beneath it. We're currently waiting on a restoration team to come out and repair things, but this won't be through Michael and Son. (It was my understanding that they didn't do the kind of work we needed done.)"