Get matched with top doors (exterior) installers and replacers in Absaraka, ND

"Had Dado insulate, sheetrock, and install service door in a garage, and insulate and put in drop ceiling in a laundry room. They were prompt, reasonable price, and always available for questions. Would hire again in an instant."

"Hello, My name is Phil Carr-Jones, I am reviewing my experience of working with and building my own kitchen, using cabinets and doors from Arkansas Wood Door. While I am an Episcopal Priest, it turns out I get to do a lot of things they don't teach you in seminary. Over the years, I have had to get fairly skilled in all the trades, including, no surprise, carpentry. But I am by no means an expert. For instance, I employed a retired carpenter to help out with the crown molding and other trim. Apart from that though, this is all my and my wife's work. So let me state up front, Arkansas Wood Doors is the go to place for the DIY’er who is thinking of remodeling their own kitchen. Here's why: I searched the web for months, literally doing comparisons and research on flat pack rta cabinets. I went to the big box store for a design and pricing in their three lines of cabinets, and I went in for a consult with a small custom shop in my area. Here's what I found. 99 outof 100 rta cabinet companies have their product made in china which means the standards for formaldehyde are going to be as fishy as they smell, plus you can only get cabinets in fixed sizes so if you looking to eeck out every last inch of space you're going to lose a lot and you'll be using a lot of filler strips wasting what could have been useful storage. If you want to go custom, then you only have less than a handful of online options, companies that will make to order in any dimension. For instance, I only wanted an 8 inches deep spice cabinet to allow for greater working room over the counter. My wife and I are pretty serious about cooking from pastries to mains and sides. We want a very serious kitchen. Plus, I'll tall so I needed the room. In any case, if you want something custom your choices online are limited. The big box stores don't really do custom and are just as limited in their options as are the online rta places. Most online rtas offer far cheaply made boxes with construction methods less sturdy. I have found that if I buy cheap, I shouldnt expect my kitchen to hold up past a few years. The finish will fade. The drawers will warp. The joints will open up. The big box stores basically offer the same thing, too. When I go to a big box store to buy something, I do it knowing I probably willl get a year out of it, whether that’s a lawn chair of a power tool. I mean when was the last time you regretting spending too much money on a better grade of power tool? So if you want quality, a better and safer grade building material and much wider choices in sizing then your basically down to three or four options. I went with Arkansas Wood Door and am completely pleased and impressed by the experience. Now I could have spent twice what I did and gone to a small custom shop and gotten the same thing, but I am in to saving money and frankly I enjoy the challenge. AWD worked with me directly. Working up the order and getting the plan for each box just right. If you have never designed and built a kitchen before, there are plenty of tips and guidance on the web and I recommend you heartily research all of the aspects and complications involved. I hit a couple of unexpected bumps. But more about that below. So do your research. For instance you can save a lot of money by building the plinths yourself and only order squared off boxes without the toe kick. By making the platform on which you place the lower cabinets first, you can get that plumb and level, so throwing up the boxes is a breeze. And again, the cabinets are also less expense, a complete all around win. AWD uses an easy system for matching up box parts so assembly was easy. No special tools required. Given the many parts and I used a mix of frameless and face framed cabinets, there was a moment or two when in amongst all the materials I got nervous about having everything I needed, but low and behold, all was right there in the end. I also recommend the concept from French cooking "mis en place" that is have all your ingredients in place and all your tools where you need them before starting out. Also, it was a lot easier to work with my wife than doing it alone, but I did a few by myself and so if that is your only option than you should have no problem. I've assembled a lot of cheaper Swedish flat packed furniture in my day, and the quality and sturdiness of AWD leaves no doubt about how long these will last. Just rock solid. Great thing about AWD is the cost to quality ratio. Cant beat it. Which also means if you make a mistake the replacement is so reasonable it becomes not big deal. I mis-measured one box and so I needed to order the right size. Worked out fine, but that was because AWD had an incredibly fast turn around. The other few reliable companies are several weeks to months. And these other places are crazy expensive. And in truth, the other companies are a complete rip off on trim and accessories. AWD pricing was so amenable that my mistakes cost me so little in comparison with what I was saving. So there's a built in confidence for the first timer. Also AWD made one mistake on the placement of a hinge in two doors. They immediately and without question remade them and sent them out in under ten days. You just can't get that service anywhere in the custom cabinet world. It was so affordable I upgraded on one side to black walnut. Trying doing that at the other quality shops. The quality of the roll out drawers and top drawer boxes is superb and the hinges and under-mount sliders are top grade excellent. The hardware was the easiest part frankly. Their system, for lining up the hardware is just so easy. Drill driver is all you need as the placement is already leveled for you. SO: high end quality custom built cabinets, superior custom support, fastest turnaround in the marketplace, most affordable pricing out there, excellent hardware, and oh yeah, I almost forget, color choices. They offer complete line of lacquer - just pick a SW color and they'll match it. SO completely and truly custom for a fraction of cost without sacrificing any quality. The Rev. Philip Carr-Jones"

H Prairie Operations is an owner operated window and door distribution company that specializes in providing the ideal product for homeowners or contractors that meets their needs at an affordable price. We will consult with you, your customer, or your contractor and make sure you receive the products you need, at the time you need them, and within budget.

Sonyx Solutions is committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers' interests, and make their concerns the basis of our business.\n

"AHS is ok. They cover repairs of most everything under the roof of your house. The companies that contract with them are not always the best. You call AHS with the issue, they send a fax to the repair company and give you the contact info. If they don't contact you within 24 hours, you call them. Sometimes they answer, sometimes they don't. When they arrive (usually three days or so later), they service the item. if it has issues within the 90 days, you call AHS again, they are sent out with no charge. If the serviceman decides the unit is unrepairable, AHS will allow you to choose a replacement from their listing (usually not as good as what you have) they will install and remove your old item, or give you wholesale amount to buy and install your own. Prices vary on what you want covered and what you want the copay to be, plus where you live. For me it is 49.99 per month with a 75.00 time of service order. You can have more than one item serviced at the same time under the same fee. If you have a SEAR product the repair guys are great. Not that wild about the other ones they send out. But it is a big savings compared to calling someone on your own. The cost of service is only the 75.00 copay."

Make a lasting impression with a new Entry Door from Sears. ENERGY STAR� rated custom entry doors provide security, peace of mind and energy efficiency. \n \n \n* Ask About 12 months no interest\n (If paid in full within 12 months)

"As soon as parts where in jtl doors was there promptly and got the job done in no time and had my family back using are garage door!!! I would highly recommend this company family owned and get the job done fast and right !!!"

"KDM was quick to respond and get the job done even with unexpected weather! My deck is now safe and I will definitely be calling them again."

We pride our company on reliability, great communication, integrity, and quality work. We are experts in our trade and will do our best to keep you as educated as we can on your particular task or project. We look forward to earning your business!\n\n

Adams Construction Supply is a locally owned and operated company that values honesty and integrity in all aspects of our business. We offer a variety of Home Improvement services that are customizable to each individual project & specialize in handyman and carpentry work. We pride ourselves on the quality of our work as well as our commitment to outstanding results. We look forward to building lasting relationships with our clients and guarantee your satisfaction!