Get matched with top doors (exterior) installers and replacers in Buena Vista, GA

"Good job on a simple straightforward ceiling install. I will use them again if needed."

"Got back to me quickly but couldn?t help me because I didn?t purchase my exterior front door from them"

"The work done on my rental house looks pretty good. Of course, there?s more to repair and paint work than what can be seen on the surface. Since I could only check in about once a day, I would generally have to trust that work was being performed to my expectations.
It was on one of my daily stops that my crisis of confidence began. Some of my vertical window moldings had concave and cracked faces at their lower ends -- sure signs that they were rotting inside. I had pointed these out to Jason, when he came to bid the job. He had said they would be repaired with a Bondo-like filler, before being painted. What I found in my spot check, was that the cracks had been filled with caulk, as if they were simply going to be painted over, with no repair to the rot. I pointed this out to the painter, and told him that was not OK. He agreed, saying they had been caulked by mistake, and that the moldings would be repaired properly. I also spoke to Jason on the phone. He apologized, and said the bad spots would be replaced with new wood sectioned in.
When I was called to the site on the last day, for final check and payment, I found that the moldings were not repaired, and had simply been painted over! I was probing them with a knife blade, but, Jason joined in with a screwdriver, gouging out rot from the moldings I had been aware of, and found several more moldings that needed repair. Jason said it would all be taken care of in the next hour or so.
We also looked at a repair he had made to a rotted garage door frame that we had discussed on our initial meeting. At that meeting, we agreed that the wood should not run all the way to the concrete -- that being a common construction error that leads to rot. We agreed that there should be an uncaulked, 3/8 inch gap, to allow for air circulation, and to prevent wicking of water. I was SO glad to find someone that understood this commonsense approach to such a common problem. But, the repair DID run all the way to the to the concrete, and was caulked around. When I made note of that, Jason said it was not a problem, because he had used pressure-treated wood for the 4-inch repair section. He might be right. He might be wrong, with the contact still allowing water to wick up to the original wood above the repair. But, the real issue is that the repair was not done as we had agreed.
I left for a while, so the rot repairs could be made, and so I might get a grip on my tension. It was about 90 minutes before I was called back. I spent most of that time asking myself questions like these: How could home repair guys either A), not recognize obviously rotted molding, or B), think it is ever OK to paint over rotten wood? How could they make the same mistake a second time, when it had already been pointed out to them? Could proper repairs be done to the rotted wood in the last 90 minutes of a week-long job? Had all other aspects of the work been done as we had agreed, and/or to accepted best practices? I DON'T KNOW, and, I don?t appreciate being forced to entertain such questions.
When I got back, Jason showed me where he had sectioned in wood to the areas of worst rot, and had used Bondo-filler on the others. As we were going over the bill, he stated that he had not charged me for any rot repair, noting there was no line-item for it on the estimate. Really? Lacking any evidence to the contrary, I would have expected that a certain amount of rot repair is figured into a paint job in the same way that a certain amount of decking repair is figured into a roofing job. At any rate, we had certainly discussed rot repair when he came to bid the job.
I?ll conclude with a point in Jason?s favor. I had taken bids from two other repair guys. I did not hire them, in part, because they resisted the notion that Masonite and fiber cement boards needed to have their backs and edges painted even where it would not show, to give them proper service life. Jason did understand this, and did see that all sides were painted. He also used a recommended primer for fiber cement products that I had not been aware of.


"

"Hello, My name is Phil Carr-Jones, I am reviewing my experience of working with and building my own kitchen, using cabinets and doors from Arkansas Wood Door. While I am an Episcopal Priest, it turns out I get to do a lot of things they don't teach you in seminary. Over the years, I have had to get fairly skilled in all the trades, including, no surprise, carpentry. But I am by no means an expert. For instance, I employed a retired carpenter to help out with the crown molding and other trim. Apart from that though, this is all my and my wife's work. So let me state up front, Arkansas Wood Doors is the go to place for the DIY’er who is thinking of remodeling their own kitchen. Here's why: I searched the web for months, literally doing comparisons and research on flat pack rta cabinets. I went to the big box store for a design and pricing in their three lines of cabinets, and I went in for a consult with a small custom shop in my area. Here's what I found. 99 outof 100 rta cabinet companies have their product made in china which means the standards for formaldehyde are going to be as fishy as they smell, plus you can only get cabinets in fixed sizes so if you looking to eeck out every last inch of space you're going to lose a lot and you'll be using a lot of filler strips wasting what could have been useful storage. If you want to go custom, then you only have less than a handful of online options, companies that will make to order in any dimension. For instance, I only wanted an 8 inches deep spice cabinet to allow for greater working room over the counter. My wife and I are pretty serious about cooking from pastries to mains and sides. We want a very serious kitchen. Plus, I'll tall so I needed the room. In any case, if you want something custom your choices online are limited. The big box stores don't really do custom and are just as limited in their options as are the online rta places. Most online rtas offer far cheaply made boxes with construction methods less sturdy. I have found that if I buy cheap, I shouldnt expect my kitchen to hold up past a few years. The finish will fade. The drawers will warp. The joints will open up. The big box stores basically offer the same thing, too. When I go to a big box store to buy something, I do it knowing I probably willl get a year out of it, whether that’s a lawn chair of a power tool. I mean when was the last time you regretting spending too much money on a better grade of power tool? So if you want quality, a better and safer grade building material and much wider choices in sizing then your basically down to three or four options. I went with Arkansas Wood Door and am completely pleased and impressed by the experience. Now I could have spent twice what I did and gone to a small custom shop and gotten the same thing, but I am in to saving money and frankly I enjoy the challenge. AWD worked with me directly. Working up the order and getting the plan for each box just right. If you have never designed and built a kitchen before, there are plenty of tips and guidance on the web and I recommend you heartily research all of the aspects and complications involved. I hit a couple of unexpected bumps. But more about that below. So do your research. For instance you can save a lot of money by building the plinths yourself and only order squared off boxes without the toe kick. By making the platform on which you place the lower cabinets first, you can get that plumb and level, so throwing up the boxes is a breeze. And again, the cabinets are also less expense, a complete all around win. AWD uses an easy system for matching up box parts so assembly was easy. No special tools required. Given the many parts and I used a mix of frameless and face framed cabinets, there was a moment or two when in amongst all the materials I got nervous about having everything I needed, but low and behold, all was right there in the end. I also recommend the concept from French cooking "mis en place" that is have all your ingredients in place and all your tools where you need them before starting out. Also, it was a lot easier to work with my wife than doing it alone, but I did a few by myself and so if that is your only option than you should have no problem. I've assembled a lot of cheaper Swedish flat packed furniture in my day, and the quality and sturdiness of AWD leaves no doubt about how long these will last. Just rock solid. Great thing about AWD is the cost to quality ratio. Cant beat it. Which also means if you make a mistake the replacement is so reasonable it becomes not big deal. I mis-measured one box and so I needed to order the right size. Worked out fine, but that was because AWD had an incredibly fast turn around. The other few reliable companies are several weeks to months. And these other places are crazy expensive. And in truth, the other companies are a complete rip off on trim and accessories. AWD pricing was so amenable that my mistakes cost me so little in comparison with what I was saving. So there's a built in confidence for the first timer. Also AWD made one mistake on the placement of a hinge in two doors. They immediately and without question remade them and sent them out in under ten days. You just can't get that service anywhere in the custom cabinet world. It was so affordable I upgraded on one side to black walnut. Trying doing that at the other quality shops. The quality of the roll out drawers and top drawer boxes is superb and the hinges and under-mount sliders are top grade excellent. The hardware was the easiest part frankly. Their system, for lining up the hardware is just so easy. Drill driver is all you need as the placement is already leveled for you. SO: high end quality custom built cabinets, superior custom support, fastest turnaround in the marketplace, most affordable pricing out there, excellent hardware, and oh yeah, I almost forget, color choices. They offer complete line of lacquer - just pick a SW color and they'll match it. SO completely and truly custom for a fraction of cost without sacrificing any quality. The Rev. Philip Carr-Jones"

"Luke's Home Services truly provides comprehensive services. There is literally nothing that cannot be accomplished or coordinated via Luke Home Services. Two words. Trustworthy and Reliable."

"very professional nice gentleman I'm very happy with there services. it was more than just a door and took other project very offerable."

"Brandon was great. He was able to assess the issue via images sent via text messages. Even though the door was a custom job from over four decades, he was able to quickly replace the deadbolt. He informed me after the job was complete that her had to make an adjustment which was totally acceptable to me. If I havea need for another locksmith in the future, I'll be contacting him solely. Thanks again, Brandon."

"AHS is ok. They cover repairs of most everything under the roof of your house. The companies that contract with them are not always the best. You call AHS with the issue, they send a fax to the repair company and give you the contact info. If they don't contact you within 24 hours, you call them. Sometimes they answer, sometimes they don't. When they arrive (usually three days or so later), they service the item. if it has issues within the 90 days, you call AHS again, they are sent out with no charge. If the serviceman decides the unit is unrepairable, AHS will allow you to choose a replacement from their listing (usually not as good as what you have) they will install and remove your old item, or give you wholesale amount to buy and install your own. Prices vary on what you want covered and what you want the copay to be, plus where you live. For me it is 49.99 per month with a 75.00 time of service order. You can have more than one item serviced at the same time under the same fee. If you have a SEAR product the repair guys are great. Not that wild about the other ones they send out. But it is a big savings compared to calling someone on your own. The cost of service is only the 75.00 copay."

Make a lasting impression with a new Entry Door from Sears. ENERGY STAR� rated custom entry doors provide security, peace of mind and energy efficiency. \n \n \n* Ask About 12 months no interest\n (If paid in full within 12 months)

"Fantastic work and customer service. I was kept informed every step of the way, and we're thrilled with our new vent-free fireplace."