Top-rated furnace / forced air heating system install or replace pros.

Get matched with top furnace / forced air heating system install or replace pros in Veneta, OR

Enter your zip and get matched with up to 3 pros

Matching on HomeAdvisor

Share some details icon
Share some details about your home project.
Match with local pros icon
Within moments, match with highly-rated local pros.
Compare quotes icon
Compare quotes and choose the best pro for the job.

Find Furnace / forced air heating system install or replace pros in Veneta

Avatar for Jco Heating A/C Electrical
Jco Heating A/C Electrical
4.8(
60
)

Serving Veneta, OR and surrounding areas

Approved

In business since 2002

Free estimates

Emergency services offered

"Right after the install one of the systems was all heating. We called the company on a Saturday and they came out immediately and fixed it that day. I love their responsiveness!"
Heat Pump Chiller
Historical House
Response time2 days
30 neighbors recently requested a quote
Recommended by96%of homeowners
Avatar for Alpine Heating & Air Conditioning
Alpine Heating & Air Conditioning
4.4(
89
)

Serving Veneta, OR and surrounding areas

Approved

In business since 2009

Free estimates

Emergency services offered

"DO NOT EVEN THINK OF USING ANY OTHER COMPANY!! Alpines electricians and installers and management are the kindest, hard-working, most competent people you could ever want. My heat pump died the week before this terrible life endangering heat wave. I am very elderly with several severe physical disabilities and live in a metal manufactured house which heats up better than my oven! Alpines kind management, when informed that the dog and I were on the verge of fainting in the house which was over 105 degrees inside, sent their installation team over the next day, despite their schedule being backed up. Alpines price was competitive and the equipment is highly rated. I am pretty certain Alpine literally saved my life, because I had nowhere else to stay or live and the temp is expected to go to 114 degrees this weekend. The two electricians, the two installers, the supervisors, and the owner were all cheerful, pleasant, and worked no-stop from about 8:30 am to 8 pm to get the new heat pump up and working beautifully with no problems or hitches. I made sandwiches for lunch and they barely stopped working long enough to eat and to rest a little. The temperature inside the house was close to or at 100 degrees, but they kept working. All the Alpine employees were kind people whom I felt very lucky to have in my house. I could write forever, but I could never fully express my gratitude to Alpines wonderful employees,"
My work.
Stained wood log home siding
My work.
My work.
My work.

+5

Response time1 day
47 neighbors recently requested a quote
Recommended by98%of homeowners
Marshall's Specialty Services
New to Angi

Serving Veneta, OR and surrounding areas

Approved

In business since 1948

Free estimates

Credit card accepted

Marshall's Specialty Services is a long-established home services company serving Lane County, Oregon. Founded in 1948, the company has grown from a small heating oil business into a full-service provider offering HVAC, heating and cooling, insulation, fireplaces, water heaters, duct cleaning, and indoor air quality solutions for residential and commercial customers. The company is headquartered in Springfield, Oregon and has built a reputation for quality workmanship, experienced technicians, and customer-focused service.

Kevin Kelly's Heating and Air, LLC
4.9(
19
)

Serving Veneta, OR and surrounding areas

In business since 2018

Free estimates

"Very friendly service answered every question I was curious about neat and clean wore boots and used plastic sheeting on my floor so as not to dirty the house very professional Independent contractor and the best price for the buck I would highly recommend Kevin he uses all new parts and even includes a cement slab for the central Heating unit outside I am very happy with my new air-conditioning system And will be calling him for yearly maintenance trust me I m tight with money that being said best service In the best price around this guy really knows what he s doing and he doesn t try to sell you something that you don t need which in my book speaks for itself also system has a 10 year warranty and that really can t be beat And he is local Fast and efficient I give him five stars"
Response time3 hrs
Recommended by94%of homeowners
Avatar for North Alabama Technical Services
North Alabama Technical Services
4.9(
124
)

Serving Veneta, OR and surrounding areas

In business since 2010

Emergency services offered

Credit card accepted

"Mr. Ferrell came to my home and picked up my dinosaur of a computer...a 2005 Dell Desktop.  For all intents and purposes, it was barely running.  If I was lucky, I was able to check my gmail and sometimes send a response.  Mr. Ferrell picked up my computer on his DAY OFF (Friday) and returned it to me on LABOR DAY.  He said that my computer had over 7,000 viruses on it. It was the most he had ever seen!  What I got back from him on Labor Day was the computer I purchased in 2005, but much better.
Mr. Ferrell installed an ENTIRE new operating system, he upgraded my ram, he re-installed his FREE virus protection.  Mr. Ferrell backed and restored ALL of my data.  And, if that was not enough, he updated my hardware system. And, he charged me $125 which I think is an incredible price due to the fact he gave me a BRAND NEW COMPUTER.
Mr. Ferrell is extremely professional, friendly, and incredibly efficient with his time and your money.  I just started using my new computer this week and I am in heaven.  No more viruses...no more waiting 10 minutes to pull up a website...and no more having to pull out all of my cords out of my modem and rebooting my computer.  I am thrilled with the job that Mr. Ferrell did and I would recommend him to anyone.
"
2014 Super Service Award Winner!
Additional Photos
Recommended by97%of homeowners
Avatar for Aegis Cleaning Services
Aegis Cleaning Services
4.1(
501
)

Serving Veneta, OR and surrounding areas

In business since 2006

Free estimates

Credit card accepted

"Background:
I picked the wrong type duct cleaing service.  Subsequently I have learned tthere are two main types of duct cleaning services... and I have found they are not equal in their cleaning ability. 
The first type uses a truck mounted large industrial-sized vacuum that is attached to the heating system with large flexible fabric 'hoses"  and sucks large volumes of air through the ducts simultaneously as a pneumatic "beater / flailing wand" is manually threaded by the operator though the ducts to loosen dust and debris contained within the ducts.  The wand is flexible and snakes around bends and right angle corners in the ducts.  The loosened dirt is then rapidly drawn out of the duct and into the vacuum bag filters in the truck.  All the vacuum machinery remains outdoors in the street or your driveway.  I've heard this referred to as a "negative pressure" type duct cleaning system.  This system requires somewhat more time to set up and a sizeable investment in equipment.  This is the type cleaning system I assumed would be used... but wasn't.  It was my fault that I was not aware that other types of duct cleaning systems existed... and therefore did not verify what type system that would be used on my job. 
It turns out the second type duct cleaning system is one that uses a rotating brush mounted on the end of long hose attached to a man-portable vacuum cart that is wheeled into and through your home (about the size of a patio barbeque).  The grills on your home's heating outlets and return air inlets are removed and the hose with rotating brush on the end is inserted into each outlet and inlet by the operator.  The hose is then pushed as far down each duct as the hose length will allow (usually 30' to 35' for the 40' hoses commonly used).  The hose typically does not go around right angle bends.  The vacuum hose then sucks up dust and debris loosened by the rotating brush... but only for duct lengths not exceeding the hose access length.    I've heard this referred to as a "roto-brush" type duct cleaning system.  This system requires much less time to set up...a much much smaller investment in equipment and can easily be transported in the back of a family SUV.  This is the type of duct cleaning system that was used on my job... but I wasn't expecting.  Again, this was my problem that I did not verify the type of system to be used. 
Aegis used a roto-brush system which didn't have a vacuum hose length adequate to access the full length of my home's ducts as it turns out.  I was not told of this situation... and the operators themselves may not have been aware of it... although they should have been.  I believe they said their hose was 40' long.  Unknown to me... but discovered a week or so later... large lengths (at least 6' to 8') of my ducts were not cleaned at all due to inadeqate hose length and/or inability to negotiate around duct bends.  Also I found that remaining dust and debris was still visable through the open outlet & inlet ducts immediately upon "completion" of the cleaning job.  I called this to the attention of the operator (while he was still on site)... who then re-cleaned these duct spaces.  This made me wonder what else hadn't been cleaned adequately.  I later found out. 
Although the two operators turning up to do the job were polite and accommodating... they did not impress me as being very professional.  Hip-hop shorts, raggedy T-shirts and flip-flops did not strike me as appropriate dress for a professional service coming into a person's home.  They arrived in an unmarked personal SUV with out-of-state plates (Calif.  I think) with the roto-brush machine loaded in the back.  After being on the job site for a few minutes...one of the two operators said he had a headache and needed to go to a drug store to get some aspirin.  He didn't return until the job was nearly completed by the second operator in a little over an hour or so. 
Their job price was about half of what I have paid in the past for professional duct cleaning by a contractor using a negative pressure duct cleaning system.   I mistakenly assumed I would be getting the same type service... but at half the price.  My error.  In the future I will only engage contractors using the negative pressure type system and specializing in duct cleaning.  To me it's worth the added price given the better results I've experience with negative pressure vacuum systems. 
For those homeowners having duct work compatible with a roto-brush cleaning system (shorter staight duct runs, no sharp duct bends, visibility allowing verification the cleaning has been done adequately, etc.)... I would check out several contractors before selecting one... to find one that is conscientious, professional and effective. 
I did not follow-up with the contractor to complain or request a re-cleaning.  I figured it would not be worth the effort given the nature of their roto-brush system and the hose lengths of their vacuum.  I simply manually vacuumed out the uncleaned sections of duct work myself as best I could... when I later had the furnace taken apart for unrelated repairs.  But, all things considered... I personally will not use Aegis again.
"
Air Duct Cleaning
Jeff & Kristin Waters
Housekeeping & Window Cleaning
Recommended by80%of homeowners
Avatar for Choice Home Warranty
Choice Home Warranty
4.0(
5,676
)

Serving Veneta, OR and surrounding areas

In business since 2008

Emergency services offered

Credit card accepted

"So far when Choice Home Warranty is needed they are right trying all there mite to complete what need that I have. I call about my heating system today and they started right then trying to locate a technician to repair or as they say replace. I just know it's very cold and we need the heat very much there is small children in the home. I believe the CHW will do what they say they'll do and more."
Recommended by82%of homeowners
James Cook Oil Heat Service
4.8(
3
)

Serving Veneta, OR and surrounding areas

In business since 1990

Free estimates

Credit card accepted

We're dedicated to providing our clients with the very best in installation, service, and repair for your heating and cooling needs. Our company is built on honesty and integrity. We specialize in central A/C and cooling systems as well as heating and furnace systems. We take pride in the quality of our work and our commitment to outstanding results. We look forward to building long-term relationships with our clients, and guarantee your satisfaction.

Response time10 mins
Recommended by100%of homeowners
Showing 1-10 of 42

FAQs for furnace / forced air heating system install or replace projects in Veneta, OR

Converting from an oil furnace to an electric furnace isn't a simple swap—the oil system needs to be completely removed before installing the electric furnace. You'll need a full electric system installation, but you might be able to reuse existing ductwork if it's up to current safety standards. You’ll need to budget for a new electric furnace installation, which costs between $1,800 and $6,200, including professional removal, proper disposal, and safe installation of the new system.

Electric furnaces are 100% efficient at converting electricity into heat. However, some of that heat can be lost as it travels through your home's ductwork or escapes through poorly insulated areas. That's why regular duct maintenance and proper home insulation are important to maximize your furnace's efficiency and reduce heat loss, ensuring consistent warmth and lower energy costs.

With proper maintenance, an electric furnace can last anywhere from 20 to 30 years, outlasting the average gas furnace's lifespan of 15 to 20 years. To keep your electric furnace running efficiently, schedule regular cleanings, tighten connections, and have inspections done before winter arrives. With routine maintenance, you’ll ensure consistent, safe heating for years to come.

The size of the electric furnace you need depends on factors like your home's square footage, climate, and insulation quality. As a general guideline, those who live in warmer climates should multiply their square footage by 30 to 35 BTUs, while those in cooler areas should multiply it by 50 to 60 BTUs.

Consulting with an HVAC professional can help you determine the exact size that's right for your home.

An electric furnace works by converting electricity into heat using high-resistance heating elements. A blower then pushes the warm air through your home's ductwork, distributing heat evenly throughout your space. Since there's no combustion involved, electric furnaces eliminate the risks associated with gas furnaces and provide consistent, reliable heating when properly installed.

An electric furnace uses between 40 and 80 kilowatts per day to heat your home. The exact amount it uses depends on factors like your home's size, insulation, and overall energy requirements. Larger homes or those with poor insulation use more energy than smaller, well-insulated spaces. A professional furnace assessment can help confirm the ideal unit size for your needs.

The Veneta, OR homeowners’ guide to furnace / forced air heating system installs or replaces

From average costs to expert advice, get all the answers you need to get your job done.