Get matched with top sump pump repair or replacers in Weymouth, MA

"I have been looking for someone to come in and service my standby generator for quite some time. I finally decide to check with Angi's for recommendations. Premier Energy Solutions responded to my query within minutes of my posting. After discussing my system, they informed me that they had a technician who was currently in my area and could come in the same afternoon. Nate showed up early in the afternoon and was able to get my generator functioning within a few hours. He took the time to keep me informed during the process and we discussed my options for going forward with a maintenance schedule."

"Our sump pump broke down and they were here within an hour! Highly highly recommended!"

"Went well. pumps replaced"

"Extremely happy with work completed. They came in went right to work, cleaned up and came in under estimate. They were professional and explained the work they did. Will definitely use them for future work."

"Very efficient, helpful, and professional. Will definitely be using them for future needs!"

"Good job done."

"The work by Anthony G. Was excellent !! He was very professional and friendly!!! Thank uou"

"The plumber arrived on schedule and did a fine job clearing the clogged drain. We will definitely use them again if the need arrises. "

"I moved into a 2 year old house to immediately find water seeping into the basement. I found some signs of it around the baseboard moldings. I called a couple of companies, one of them Drycrete and another, an interior french drain company. The french drain company wanted to jack hammer my finished basement and install one of their systems, an additional sump pump, and a ton of exterior work for pump discharge. That was going to cost 15-20k. Drycrete on the other hand, walked around the perimeter and noticed the obvious - foundation cracks. Those are cheap to fix, but not a guarantee. In any case, I decided to start from the top down, cracks first, 20k french drain later. The process for a crack seal is pretty straight forward and if I wasn't as pannicked I would have attempted it myself. They used Poly to inject into the crack and it worked. The basemet is dry. My sheetrock is open and the wall is still bare from the spray foam along the crack lines. I constantly measure the moisture content in the baseplates and it's slowly getting back to normal. But the moral of the story is - whatever company you bring on to a job site, whatever sperialty it is that they do, that's the solution they will likely propose to you. Drycrete did a good job as far as getting the right diagnosis. If I had to change anything about my experience with Drycrete, maybe I woould have requested for them to put up Zipwalls around the work area. Drywall and concrete dust went everywhere. Overall, good work y'all."

"as advertised"