Get matched with top geothermal heating or cooling system installers in Bothell, WA

"Great! Very happy with the service, knowledgeable staff and quick installation of the mini-split system. Best heating system I've ever used."

"Of the eight companies who bid, Greenwood did the best assessment of the somewhat quirky situation my old house presented. The estimator came just a few days before the big freeze in January, and they were able to schedule installation within two days. Once the installers were on site, there was some confusion re where various components would go, but a phone call to the company cleared that up within an hour. From then on the heat pump installation went smoothly and professionally, the electricians did a quick and effective job of hooking it up to the service, and the site was left clean. I did not understand at first how to operate the thermostat, given that the Mitsubishi owners manual was of limited help, and per my request a rep from the company came out a few days later to give me a tutorial about what the range of settings can do. From then on the system has operated flawlessly and lives up to its reputation."

"I purchased a new Navien NPE-240A2 Tankless Water Heater and had it installed. I'm loving the new water heater. It replaces an old Noritz tankless that died just before this installation. The on-site estimate was what sold me. Ken went through all the details and answered a lot of questions from me. Zachary came out with Austin and performed the installation just like I discussed with Ken. Zachary kept me in the loop throughout the installation to ensure I was in agreement with how it was going. Zachary always had my interest at heart and ensured no corners were cut. The installation is much cleaner, and more correct than the previous tankless company did. Zachary even listened to my concern about the astectics of the exterior exhaust and quickly found an easier and cleaner looking way to address my concern. He also removed an old recirculation pump and replaced a new main house shutoff valve. The entire area was treated respectfully and left cleaner than they found it."

Janes Radiant Heating is family-owned and specializes in high-efficiency radiant heating systems across Western Washington. We provide emergency boiler repair services for households throughout the Puget Sound area, the Islands, and the Peninsula. With over 35 years of experience and 20,000 installations under our belt, you can trust that our radiant heating experts will work hard to get your system up and running again. \n\nWe are the state's first and largest major installer of radiant floor heat systems. Whether you need an installation in a new or remodeled home, or an upgrade to an existing system in your current home, we bring unmatched knowledge, craftsmanship, and commitment to every project.\n\nOur showroom and warehouses are located in Mukilteo, WA, and our team of factory-trained, specialized technicians is stationed throughout our service area, with the most common parts on their trucks. Our friendly service team is here, ready to take care of you!

All Climate Heating & Air Conditioning has been serving the Greater Seattle area homes and businesses since 1993. We provide quality heating, cooling, and home comfort services, while also keeping Seattle homes and businesses clean, energy efficient, and comfortable.

"From our meeting with the salesman through installation and charging of the air conditioner, these guys were first rate. We spent about 2.5 hours with the sales rep going over our old system, the configuration of our house, and our heating and cooling preferences before coming up with a recommended package. We purchased during the shoulder season and a crew was free the next day so BF was anxious to get that hole filled and we ended up getting a good system at a pretty fair price. The electrician was the first to arrive followed by the rest of the crew at 9:00AM. By 6:00 they were finished and they left no traces behind. Very tidy crew. Got a phone call from their scheduler the next day regarding the refrigeration inspection which they fully coordinated. Got another call from them regarding the inspector's arrival window. He had 2 minor things he wanted them to take care of which the tech who charged the A/C promptly dispatched. Every one of their staff we spoke with was happy to answer any questions we had and they were great about educating us and keeping us informed about what they were doing and why. This is the first time we've used Blue Flame and I hope they are as good with the service as they have been with the initial installation. So far, we're pretty happy campers and will definitely do business with them again."

"Rob was very professional and took his time verifying all amps and voltage. He even took the blower off to vacum out the ineterior. He inspected the gas pressure too. Everything checked out well and he did a throrough cleaning. Cozy Heating did a GREAT job. I will definately use them in the future.
"

"The installation of our new heat pump was to take two days, and I assumed would be done during normal business hours (8:00AM - 5:00PM). I expected a smooth process and a properly working system at the end of the 2nd day. The experience was not even close to my expectations. Day 1: Old air handler, heat exchanger, compressor pad and compressor were removed; new air handler, heat exchanger, and compressor pad were installed. As expected, the new compressor was placed on the pad, but not connected to inside unit. I observed one of the four-man crew scraping gravel from my neighbor's driveway to put under the compressor pad. When I told him that my neighbor probably would not like that, he said, "It will be OK. I'll smooth out the places I took it from." He couldn't have given a more wrong answer! Late in the afternoon, the electrician (an Overlake subcontractor) arrived to hookup power to the new system, and all four from the installation crew left. (I think at least one of the crew should have stayed until the electrician was finished to verify that the system was working. And maybe to explain to me how to operate the new thermostat!) About 90 minutes later, the electrician was finished, but the system would not turn on. It was not his job to troubleshoot system problems, but with the guidance of someone over the phone, he managed to find two wires that had not been connected by the Overlake crew. He connected the wires, but that made no difference. I was supposed to have backup electric heat working at the end of Day 1. This was important because it was December and the temps were down to 32 degrees at night. After 2 hours of trying to get the system to produce heat, the electrician left at 7:00PM, and an Overlake tech arrived at 8:30PM. At 10:00PM, the tech determined that a circuit board in the air handler was defective, and a new one would have to be obtained and installed in the morning. I managed to get by with two 1500-watt space heaters by closing off most of the rooms. Day 2: Before the techs arrived, I noticed that the compressor pad, with compressor installed on it, was significantly out-of-level. The techs arrived at 10:30AM, and I asked them to purchase a bag of gravel to replace what had been taken from my neighbor’s driveway, and they complied with my request. I also asked them to level the compressor pad which they did. The defective circuit board was replaced, and backup electric heat came on. It took two Overlake techs until 7:00PM to connect the inside and outside units of the heat pump, and attempt to charge the system with refrigerant. However, a valve on the compressor unit was leaking so the heat pump could not be operated until a new valve was obtained and installed the following day. Day 3: Two Overlake techs arrived at 1:30PM, and, I assume, they installed a new valve. What appeared to me that was left to be done at that point was to charge the system with refrigerant, connect a small electrical cable between the inside and outside units, insulate the refrigerant lines, and spot-tie the lines and wires into a neat installation. This seemingly small quantity of work took until 10:00PM to complete, at which time it appeared that I had a working system. Day 4: I had programmed the wi-fi capable thermostat using the owner’s manual on Day 2, so I woke up on Day 4 to two emails from the system telling me about urgent notifications that had occurred in the middle of the night. They were Error Code 99’s – High Torque Lockout. A google of this returned a manufacturer’s document that explained this code was likely due to overcharging the system, and resulted in the compressor shutting down for a while and then restarting for a couple of hours when the error situation occurred again. I called Overlake and they said to run the system only on the electric backup until a tech could come out 4 days later. I think Overlake should have sent a tech out that day since, at that point, they were already two days late providing me with a working system. Also, since my old but still working heat pump had been turned off 3 days before, I was going to be using electric backup for 7 straight days (at least), and that more than doubles my heating bill, at this time of year. Days 5 thru 7: Waiting for tech to return and troubleshoot error code. Day 8: Appointment for tech was scheduled for between 11:00AM and 1:00PM. Tech arrived at 4:00PM, but did call to say he would be late. Between 4:00PM and 10:00PM, the tech removed the refrigerant from the system and then recharged the system with refrigerant. He had determined that the initial charging had been below spec (too little refrigerant was used), and he said that the system should work OK now that it was properly charged. After the crew left, I noticed that there was dirt, installation scraps, and some kind of cream-colored lubricant on the carpet next to the air handler, as well as trash in the crawl space and outside around the compressor unit. In general, they could have done a better clean up. Also, they apparently used the top of our clothes dryer as a work bench since there was a drop of dried, blue PVC solvent on the dryer along with many dirty finger prints. The system has now operated for 5 days without any obvious problems. I now have an installed and operating system; however, given that it arrived from Bryant with two faulty components, and the installation included two wires not connected and improperly charging of the system, I have little confidence in my new Bryant heat pump. However, among all the negative aspects of this project, there were a couple positives: Overlake’s price was almost $2000 lower than their competition, they promptly submitted the necessary data to Bryant for the rebate I was due, and they appeared to provide a neat and proper installation."

"Furnace failure during the night. T-stat showed recognition to draw heat, but furnace was non-functioning. This company was recomended by Highlander HVAC - which did not provide service to this series. Cardinal responded in the time frame (early morning). A broken wire was found in the T-stat. Adjustments were made to improve efficiency. I asked for room temperature balance suggestions and was provided options to consider. I appreciated the service tech's insite to this 4 year old equipment. I now see that I should have conducted more due-diligence prior to my original purchase of this Carrier series. We have decided to enter into a yearly maintenance agreement with Cardinal HVAC."

"In June of this year I contracted with a large company to install a new heat pump at our residence.  While overall I felt they did a fairly decent job there were at least three instances of inconsistent service, attention to detail and disappointment.  The most disappointing aspect of that company's performance was when it came time to "test" my existing insulation and duct work.  I believed there bid to correct my existing ducts and insulation was outrageous.  That said, I was in between a rock and a hard place.  I had just installed a $12K heat pump and I feared any efficiencies I may have gained could be lost due to my existing ducts and insulation.
I contacted 5 companies to provide me with bids, in addition to the upsell price I was previously provided by the company I had install the heat pump.  All five companies are listed on Angie's List.  They all provided fairly consistent bids.  They all helped educate me on what I may need to resolve my existing duct and insulation issues.
Daniel was the final contractor I spoke with.  He showed up early afternoon, looking a bit haggard, as if he had just emerged from a crawlspace - he had.  I was somewhat tentative at first, but I knew I had found the right man for the job the minute he began outlying in detail everything he saw, what he would recommend, how he would address my specific issues and what it would cost.  He was upfront from the get go, wanting to work with my budget and my timetable.  
Daniel and his team showed up three days later and worked 12 hours on a Saturday in 85 degree heat, completely insulating the crawlspace of a 2,000 sf home.  He was back the next day to finish up, working another 7 hours, again in 85 degree heat.  He pointed out certain issues he found along the way, specifically some holes that needed patching with mesh and sealing all gaps in my flooring from the crawlspace.  He sealed all the ducts, adding screws where necessary.  He even sealed the holes drilled by the company who installed the heat pump (one example of their service inconsistency).
Daniel is an extremely hard worker.  I have the utmost respect for his abilities and would recommend him to anyone looking to have any type of crawlspace / insulation work done.  Sure, shop around, talk to the various companies on Angies List, get educated and then do what I did, call Daniel last, negotiate a price and get the job done right.


"