Get matched with top doors installers or repairers in Bowdon-junction, GA

"Very well. The slight dip in the kitchen looks better and the doors trued up. The slight sag still in the kitchen floor is because of the sub floor plywood which I didn't want to get in to. They leveled the joist by shimming the tops of several cinder block posts and installing a pair permanent of steel posts under a section of joist the previous owner had cut in two."

"quality is always excellent. Delivery has always been on time. this is the third time I have used Arkansas wood door"

"Luis, the owner, is great to work with. His installers (Mike and Dillon) are equally as great. They have a very good product and their service and attention to detail is top notch."

"They took off one of the bi-fold doors to get to the dryer and put it back 1/4" lower than the other."

"They couldn't fix my storm door, but I'm giving this rating because it needs to be replaced and was out of their control. They installed something else in my home, and for that I'm extremely grateful. Didn't want them to waste a trip! Lol"

"I met the owner, Benji, in June after a small fire in my home that occurred back in February. The first restoration company that we used had to be fired because they did absolutely nothing for 3 moths. Benji was a God send, he promised that he could restore my home to its condition prior to the fire as well as the majority of the renovation/remodeling and act as my general contractor. I hired Advanced Quality Constructor for the job in June 2022. The framing jobs that he performed were all excellent with the exception of the one of the beams in the kitchen that was apparently cut during the demo but it was the beam of a load bearing wall so that needs to be fixed. The demo and framing that was done in the attic conversion also looked good. The issues started in areas where he didn't have or use the correct tools to do the job. The Master bathroom demo and renovation took almost (3) months for just 1 bathroom and once it was completed and inspected it was not done to my satisfaction. Due to using a circular saw instead of a table saw none of the cuts of a bathroom with tile for floor to ceiling were cut correctly. Each tile has very noticeable rugged ridges. Because of the continuous starting and stopping over the 3 months roughly 75% of the tile is either uneven or visibly crooked. The grouting is incomplete and was never even cleaned off. In the tile shower you can see indentations from each of the individual floor tiles grids. All of the edges of the tile will need some type of trim or crown molding to hide the rugged cuts. The bathroom vanity is a floating vanity and if you lean on it it moves like its about to fall off the wall, it's being held up by pieces of wood behind it that you can see because it wasn't mounted to a stud. He tiled the entire wall and then went back to mount the vanity. It's only been a month and the caulk is already beginning to crack. The shower head is leaking and running down the wall when you turn on the shower so I'm concerned that the leak is also happening behind the wall. My plumber said that it likely is and that I should remove the tile to double check. The hand shower does not work because he used an old handset from a different fixture instead of the one that came with the showered that I purchase. The wall mounted plumbing fixtures purchased for the standing tub are crooked and need to be taken out and redone. The door trim around master bath linen closet was removed and never replaced so now theres absolutely no trim around the door and there a piece of tile that was never cut that hangs about a foot and would prevent a door from being able to be closed anyway. The tile around all electrical wall switches is so unevenly cut that you can't use separate covers. I ordered jumbo size covers from Amazon that I'm hoping will work. The hot/cold faucets on the double sink are installed in the wrong direction so hot is on the right, cold is on the left, and they're faced inward instead of outward. Theres piles of lumber that was left, feet of sawdust that was never swept up, trashed lumber in my driveway that could have simply been put inside of the dumpster instead of leaving it around the dumpster. I also purchased a table saw that I was to be reimbursed for. The most hurtful thing is that I paid in advance for work that was never performed."

"It was messy but that is to be expected when working on sheet-rock and carpentry. The work itself turned out very well. The job was to enlarge two closets, repair wood and sheet-rock, install two large doors with mirrors, casing, and paint. Good carpentry work; we had a couple of problems but he immediately asked what we thought and did not try to cover or hide the imperfection. Mr Tolbert was willing to redo a part that was not perfect - his suggestion. That, perhaps, is the most important quality: if something is not right, he will tell you, discuss ways to improve, and redo if necessary. He brought a helper to paint two rooms and the helper too was very professional. I would definitely hire him again to do carpentry, painting and other handyman work. My only 4 star instead of 5 was because it took him a while to get back to me with an estimate and a possible start day - that could be because he is overwhelmed with work. We had expected 4 days of work: 1 per closet, and 1 per painted room. He finished in 3 days (once he got a helper it went faster)."

"He was very nice to talk with and repaired our washing machine. He even helped sweep the water out."

" This is my third service by this company in eleven years and I allways get professional and prompt repairs. The service charge is sixty dollars to come plus repairs and parts."

I come from a long line of Carpenter/handymen who pride themselves on quality craftsmanship. This is a Family owned and operated business and we are dedicated to customer satisfaction and building a good customer relationship. Quality work is our #1 priority!